Solar Pool & Spa Heating DIY Kit 4sq/m Kit

• Solar pool heating can double the number of month you can use your pool. Our DIY kit is one of the easiest and most cost effective ways to install solar heating. Install almost anywhere on the roof of your house, garage, porch, shed, pergola or directly on your lawn. Everything you need to build or expand a system comes in a range of boxes.

• 4sq/m Solar Kit Includes.
• 1Mtr. X 3MtrSolar Collector
• Fitted Click Stop Stop-Manifolds.
• Nylon Band Click Stop Adaptors.
• Installation Guide

High Quality / Low Cost
The only important requirement is a sunny location i.e. north / northwest facing surface to ensure maximum heat exposure.

Plumbing Kit Contains:

10 x Snap Saddles
1 x Vacuum Break Valve
10 x 90 Degree 40mm Elbows
2 x 40mm Tee
2 x 40mm Threaded Adapters
1 x Check Valve
1 x Hand Valve
1 x Clear Solvent Cement (for PVC pipe)
1 x Roll of Teflon Thread Tape

With most single storey installations your current filtration pump will have adequate pressure to pump water through your ReadySolar collector, normally up to 6m high. your water flow pressure will vary depending on the power of the filtration pump and plumbing configuration etc. Click here for Pumps or Solar Controllers (if required)

Using your pool filter pump, water is pumped through the ReadySolar matting with is heated by the sun. The matting is pre-fitted to PVC manifolds that are simply clicked together. The Manifolds must be plumbed directly to the filtration plant (or separate pump). The amount of ReadySolar you will need to raise your pools water temperature efficiently will depend on the size of your pool (See chart Below)

INSTALLATION GUIDE
(PDF Format)

 ReadySolar is available in two different matting sizes (non-interchangeable).
Use the chart below to decide which kits you will need to purchase to suit your roof and pool size. ReadySolar recommends minimum 70% of pool size. Increasing will improve efficiency